**73 Scamp Mini Pro-Street Engine Swap**

Went and got some wire today for wiring the Bosch Relay in for the N Safety. Pulled the seat and went to work. I got the shifter all hooked up, TB & N Safety all wired in. Put in 2 Gallons of trans fluid and fired the car off. It is all back together with only a couple minor clean up things to do.

I fired the car off in N and let it warm up while I adjusted the Vac Pump. It is pulling right at 4hg Vag at idle and 15hg Vac at about 4500 Rpm. If I revv it more it goes higher. I am still on stands so I didn't want to go too crazy. Once I got it all warm, checked the trans fluid and it was a little over full but the trans was not hot. Close enough for now. Once I take it for a whirl around the block I will check it again. Pretty sure it will be dead nuts at full.

So I put it in gear and tires started rolling, shifted 2nd, 3rd. All is good. I put the car back in 1st and turned on the Transbrake with my foot on the brake pedal, I press the button, let go of the brake pedal..... Tires are not moving, rev it up a bit and let the button go. BAMMM, tires move forward.... Lets try that again on the 2 Step........ Foot to the floor Tach is bouncing off 3500 Rpm, let the button go..... Bammm, tires take off......... Put car in reverse, no tires moving..... Push TB Button, Tires move in Reverse.

All is working good! Tomorrow I am going to try and break away to get the new 325/50/15's mounted so I can take it out for a spin.

View attachment phpn6rVAUPM.jpg

View attachment php08UqVrPM.jpg

View attachment phpk93KiNPM.jpg

View attachment phpwLw9cQPM.jpg

View attachment phpCwVa70PM.jpg

View attachment phpHOovU7PM.jpg

View attachment phpLZtfpsPM.jpg

View attachment php2GreuXPM.jpg