1966 Dodge Dart

Also John The Body man was here and started fitting the rear quarters. Hes going to use the 3M glue for the fenders and told me to use it when putting the small plugs in where the molding strips were fastened down. Going to be the fall until much body work gets done but at least have an idea what we will be doing. I started to strip the engine compartment but before I paint there I want to fit the motor with the headers and steering on so I am sure everything clears everywhere. When cleaning out inside the firewall and outside vent area I see there must have been criters living in there! I'm not sure how to get to that area to sand for painting but I am sure there is a way! I will be removing the fenders to clean up the welding I did. Will be easier when painting as well. Here are some pics of this work.
View attachment DSCN3108.jpg

View attachment DSCN3110.jpg

View attachment DSCN3111.jpg

View attachment DSCN3113.jpg

View attachment DSCN3114.jpg

View attachment DSCN3057.jpg

View attachment DSCN3061.jpg