Another Mopar Off My Bucket List - Barracuda Fastback

After removing the last experiment I cut some lace to try next. Don't worry. I'm not in any trouble. I left our tablecloths alone and bought a few dollars worth of fabric from Walmart.

I assumed that the lace would need to be stretched slightly to remove any wrinkling there might be and that I would only be able to give it a light coat to prevent it from soaking the fabric.

img_2312-jpg.jpg

img_2313-jpg.jpg

I still had the area masked off from before so it wasn't much work putting the lace down. The garage isn't very well lit so it's hard to get good pictures of the gold on the black.

img_2314-jpg.jpg

img_2315-jpg.jpg

After removing the tape I could tell that it was going to need a pinstripe to outline the panel. I chose orange because of the orange metal flake that is on the side lettering. (- and because I didn't have anything else)

img_2316-jpg.jpg

img_2317-jpg.jpg

img_2318-jpg.jpg

Hopefully everything will tie together once I get the gold paint on the sides of the car. The pinstripe does help to finish off these small panels.

img_2319-jpg.jpg

img_2320-jpg.jpg

img_2321-jpg.jpg

Now I need to duplicate this on the other side of the hood. I probably should have cleared the first panel before removing the mask but I wasn't sure if I wanted to keep the lace effect until I saw it uncovered.




View attachment IMG_2312.jpg

View attachment IMG_2313.jpg

View attachment IMG_2314.jpg

View attachment IMG_2315.jpg

View attachment IMG_2316.jpg

View attachment IMG_2317.jpg

View attachment IMG_2318.jpg

View attachment IMG_2319.jpg

View attachment IMG_2320.jpg

View attachment IMG_2321.jpg