Slant 6 Turbo 68Dart Project

Sadly Jr, I've been wiping it down with alcohol and other degreasers and can not find a part number, but when I take it off to check everything out hopefully i find one. My J pipe is a 12" diameter so it directs it way further out, and will direct the intake side just past the side of the radiator. The intake piping will likely touch it on the side, but I'll figure that out hopefully.

Good to know that the extension will work, but it wouldn't be difficult to make another and I do have a flaring tool.

My other thought was to flare the exhaust pipe bend on the manifold side and slip the exhaust flange on, so that you can spin the bend before it's tightened, if that makes sense? But would likely be difficult. I only plan to tack and move, till I am happy. With mine so far forward I get to utilize a lot of room to setup the wastegate. I also am using a supersix manifold so it's still hugging the block. The downpipe will direct right at the fender if I went straight back - so it will do a angle inboard, then go straight down (angled slightly) and over the J pipe and back. Basically trying to keep as much heat away from wiring as I can. The intercooler is literally only making a 90* with a single elbow connector and it will be right below the turbo, so only about 12" of piping will be seperating them.

Basically mine goes out farther and the turbo will be taking the place of the battery, if you get the idea, so the intake and fan will never bother eachother. I'm going to make a large bracket off the block to support it and hopefully all is well. If I have to I'll make a hanging bracket with the lifting points on the head that will sweep in a "J" and then connect to the turbo bracket as well.

One other thing I thought about - maybe you'd know Jr or bill, is if I could use that small hole intended for a built in wastegate on the exhaust impeller housing? That way I make my downpipe with a 3" pipe, welded to a 1" pipe that branched off a little to attach the wastegate, and then reattached to the downpipe further down. Basically - could i not run it off the J pipe and instead run it out of the housing hole designed for internal use, it is before the impeller.