1967 Cuda FB project

Went out into the shop and decided to change the door handle on the pass door. Here is the donor handle. Neon door. Cut out section of door with handle opening in it.
View attachment WP_20141221_006.jpg
View attachment WP_20141221_007.jpg
View attachment WP_20141221_009.jpg

Install the window tracks and latch mech to see where handle is to be located. Position handle section to make sure everything has clearance. Mark hole approx. 1/2" smaller than handle section. I flanged the handle section with a flanging tool I have.
View attachment WP_20141221_010.jpg
View attachment WP_20141221_011.jpg
View attachment WP_20141221_012.jpg

Welded in and ground down. I like the newer style handle. Notice no keyhole? I used the rear door from the Neon because the Cuda is going to have keyless ignition. Walk up to car with fob in pocket, door unlocks automatically, get in, push start. Engine starts and drive away. Push start again, engine stops, get out of car, walk a few feet away and doors automatically lock.