1967 Cuda FB project

This morning I fabbed up the rods and clips for the pass door handle. First thing was to get rid of the pin the original door latch had. Grind off the backside of the pin so it's flush with the lever, then use a punch and push it out of the lever.
View attachment WP_20141222_001.jpg
Then you have to drill the hole bigger to accept the plastic clips from the neon donor.
View attachment WP_20141222_002.jpg
Then fabbed up one of the donor rods to reach the inner door handle. The inner handle also has to be drilled out to accept the plastic clip from the donor neon parts.
View attachment WP_20141222_003.jpg
Then I took one of the donor rods and made the linkage rod for the handle to the latch mech.
View attachment WP_20141222_004.jpg
I also made the lock hole in the top of the door bigger to accept the neon lock tab. Prolly didn't need to do this but I think this type is harder to "pick".
View attachment WP_20141222_010.jpg