1967 Cuda FB project

Here is the housing with the mock up carrier in it.
View attachment WP_20150111_009.jpg
Here the shaft is inserted into the carrier plugs. then you find the correct plug for the axle bearing and bolt it onto the end of the shaft with the bearing housing.
View attachment WP_20150111_010.jpg
Slide the shaft in until the bearing housing is touching the axle tube. Don't freak out if there is a little misalignment, these housings were not produced with high tolerances. If the axle gets more than this out of alignment, I will cut the housing close to the diff carrier and bring it closer to tolerances.
View attachment WP_20150111_011.jpg
Welded up and ready to have axles shortened!!!!
View attachment WP_20150111_012.jpg