T/A Cheetah SCS users step inside!
Well..... I think I got it! Pulled the valve body out and started grinding on the "rooster comb". Hit the 1st detent with the Dremel a few times until I could hardly move the lever on the bench..... also shimmed the spring behind the ball. Herding cats is probably easier than getting that dang ball back in postion while installing the lever! Actually had good "feel" on the shifter. I left the rest of the detents alone as the gate from 2-3 will prevent from overshooting that one as long as you don't pull the lever beyond the gate. I've always found it works best to "slap" this shifter on the shifts.
Well..... I think I got it! Pulled the valve body out and started grinding on the "rooster comb". Hit the 1st detent with the Dremel a few times until I could hardly move the lever on the bench..... also shimmed the spring behind the ball. Herding cats is probably easier than getting that dang ball back in postion while installing the lever! Actually had good "feel" on the shifter. I left the rest of the detents alone as the gate from 2-3 will prevent from overshooting that one as long as you don't pull the lever beyond the gate. I've always found it works best to "slap" this shifter on the shifts.
