Another question about windshield installation

75 duster, but I think all lockstrip installs should be similar... I used 3 different sealers; butyl from caulk tube(NAPA) in lower shelf, 1/4" rope caulk seal in the outside of the gasket. Install gasket on metal. Set glass into bottom. Use plastic tools to work the lip of the gasket around the glass while 'encouraging' the glass to seat by smacking it with palms. When completely in - run a small amount of Windoweld (caulk tube)under the edge of the gasket. Put the lockstrip in. Clean up squeeze out. Scrape up what you can and finish with mineral spirits or laquer thinner.
Everything must be warm! Cold gasket=bad day. LOL