thank you sir for the response, looks like some pretty nice work. how much additional are the extra pieces your talking about and what about shipping to 25901.
Shipping to WV is probably around $50-$55, shipping for these manifolds to NY or NH is usually $65. I also insure them for $350 so there's no loss in case of damage in shipping. The manifolds I sell are sand blasted, checked for damage, sprayed with high heat primer, top coated with high heat paint, heat cured at 150 degrees for 12 hours. The straight stub "properly flared" down pipes sell for $30 per side. The 340 driver requires a flat flare while the 360 magnum requires a bell flare and the adapter flanges (to bolt them up) are included. The "NEW" super tight radius 340 piece sells for $75. The $75 is a little high but I have to buy the adapter flange, buy the flared stub pipe, buy a section of 2 1/2" mandrel bent 180 pipe then cut and weld the whole thing together. If you had to buy all the parts yourself you spend more than $70 on the parts alone, without the welding and fitting. Here's an example of a fully welded 360 mandrel bent donut if you had to buy one, check the shipping. Evidently these aren't sold in the US fully welded!! Nobody sells a tighter radius than the one I buy (that I know of).
The only way I can break even on this 340 180 degree down pipe is to buy the donut and cut it into tree pieces so I don't lose money!! Again...you can't get this at any muffler shop without having to pay through the nose!!