line lock dosnt seem to work ?

I'm setting up some new gadgets while I wait for the motor. So i made a line of new switches and already got the fuel pump on one and now a new line lock on another. I didn't plum it like the instructions said (after the proportioning valve) i did it the easy way (before the valve). well whatever it is it ain't working right. I took a charge 12 volt motorcycle battery I have and hooked it up to the electrical system for power and it seemed to run the new fuel pump great and the switch lit up fine. But now when I go to use it to test out the line lock the switch looks a bit dull and the linelock doesn't seem to click convincingly, and it surely doesn't stop the front tires from rolling as the front end is all jacked up 4 motor swap. I bled the system, it seems good and hard but yet the linelock doesn't seem to hold and again I'm getting a dull light on that switch? help would be appreciated! I'll put some pictures. mind you all, these pictures are not with the wires connected. I even tried straight to the battery itself without running it through to switch with out any good result there either.View attachment 20150108_151949.jpg

View attachment 20150108_152036.jpg

View attachment 20150208_164649.jpg

View attachment 20150208_164710.jpg