67 cuda FB progress UPDATE

After you are this far and it's looking pretty tight, go ahead and trim off the excess material.
I'd leave a bit glued down the A-pillar as this will help keep it tight in the corners after the trim is put on. If there are small wrinkles left, you can use a hair dryer or heat gun to heat it up and pull to the sides. Keep the heat gun about a foot away from the material and keep moving it around. if not, you will melt the material and you will have to start over again. You can also re heat the glue and pull slowly at the edges to tighten it up a bit more. The glue will reset it's self again after your done pulling it into place. Good luck!
It worked great for me. Now on with the glass install.

View attachment 0212151818.jpg

View attachment 0212151819.jpg

View attachment 0212151831.jpg

View attachment 0212151831a.jpg