Slant 6 Turbo 68Dart Project

Ok head is back from machinest and they had to take off .008 because the head was warped pretty considerably, but it's all straightened out now, and ready to go back on. They suggested the purchase of some higher strength studs in the future. Hopefully you all are learning from this, because I am... :D They also extracted the broken head stud for me.

I cleaned all the lovely exhaust deposits off the block and did a little touch up.



Waiting on the gaskets for the T3 bracket to come. I trashed the other one when taking it off, and the rear bracket to bolt to V band, so I can just bolt the new turbo right in where the old one was. I'll need to reweld a little too, one of my welds had some pores in it that was leaking exhaust. I don't think JB would work for this either.