Trans (&engine) install ?'s (anyone near Sacramento willing to come by & help?)

Fishy68,
Thank you again! I am running a 360, .30 over, cam, KB pistons, Edelebrock RPM intake, roller rockers... It is a Hughes 2500 stall and I do have a B&M flexplate for it.

I will measure and find out as that was one issue I was having determining the yoke as I didn't know what to measure. Also I have a driveshaft or two here, one that was in the car but not sure if it was ever hooked up to the 8 3/4 rear or not. I need to measure it also to see if the joints are the same size as the 8 3/4 or if I am going to need to have a driveshaft built. Those tabs I realize I don't trim, wasn't sure what people were talking about with the truck housing but I guess the only way for me to make sure if it is all going to fit is to drop it in and see! Hoping to do so this weekend..

I did find a small bracket that was labeled "Transmission" in my parts bin, and I believe it is the kickdown linkage bracket. Always something for sure!