1967 Cuda FB project

Finally found where I packed the remote wiper motor assy away at. Started looking at a way to make it work on the Cuda. The shafts for the remote assy were way too short to work. So, I had to figure out a way to make them work. Here is a pic of the two different pieces I had to work with.
View attachment WP_20150313_002.jpg
Taken apart to evaluate the mods needed. In this pic I have already removed the gear from the short shaft assy and fitted it to the stock wiper stud.
View attachment WP_20150313_003.jpg
Then I drilled out the hole in the remote assy base plate, put it together and tigged the gear to the shaft.
View attachment WP_20150313_004.jpg
Here it is all put together. It uses a coiled wire/rope type of "chain" to run the gears for the shafts. This "rope" goes in an aluminum tube that is flared a little on the ends and then clamped between the two halves of the gearbox. Whatever length you need. You can then bend the tubes to position the shafts and the motor wherever you have room for them.
View attachment WP_20150313_005.jpg
I will get some pics of the rest of the setup later.