1967 Cuda FB project

Decided to add a K&N filter into the fresh air system. Going to use the pass wheel well for the location. Had to make a box for routing because the cowl is not directly connected to the wheel well. Figured I would use a small section in the engine compartment for routing inlet. When it is all smoothed over, it will blend in a little better, I hope.
View attachment WP_20150317_001.jpg
View attachment WP_20150317_002.jpg
Here is the section I cut out. You can see drain holes, etc. in the side by the hood hinge. So, it wasn't totally sealed for no air. But those little holes were probably not going to allow a lot of air. My filter probably isn't going to be big enough but it's better than nothing.
View attachment WP_20150317_003.jpg