Gaskets?
I bought the 3-piece exhaust set (6 pieces) for a 68 318 engine, my original in the B'cuda. They are a pain to use unless you have studs. LOL
I decided against using the 318 manifolds and opted for some 92 Dakota manifolds. I had to do a little tweaking but both sides fit.
BTW, that's a really nice looking engine setup you have there, sireland67. You are just basically using the magnum shortblock? The rest is LA?
Not to hijack the op thread but.
It is a 5.9 mag with Eddie mag heads.
LA timing chain cover, oil pan, and valve covers.
Right now I have no use for it, they
were building a 1/8 mile drag strip 15 miles from me.
It has way to much compression for the street 11.3 static, 10.1 dynamic.
It has actually been sitting not started on the same engine stand for a few years.
KB107 pistons, crank turned, bottom end balanced, SFI balancer and flywheel, Eddy heads, Comp 1.6 roller rockers, Comp 280HR cam, M1 intake. Idles at 900 rpm.
Need to figure out how to get the compression down, my engine in my old truck is getting tired.
I know I can put a larger cam in it to get rid of the compression, but it most likely would run bad in my old farm truck.