/6 to V8 CLUTCH AND HOUSING

What year Dart ?

If its a '63 the V-8 won't fit without moving the wiper motor and modifying the firewall.

In any case you will need a V-8 center link to clear the oil pan and you may have to modify the engine mounts on the crossmember .

You will need Disc Brakes in the front . Use the late big bolt pattern spindle , upper control arm and rotor from a '73-76 A body . They were offered with a manual disc/drum master cylinder or power booster but you may not have room for the power booster with the V-8.

You might want to go with a hydraulic clutch to save the mickey motion linkage, it will open up the real estate needed for the exhaust system.

You will need a mini starter also for exhaust clearance.

You will also want at least an 8 1/4" rear axle with 10" brakes from an A body, 3.21 gears for all around driving.

If your a 63-65 you will need a complete driveshaft made.

If your a '66 the driveshaft will be easy.

Of course a floor shifter is the way to go and this will require a hump on the side of the trans tunnel.

And of course you will have to notch the drivers side cross member for the exhaust pipe.

But the simple solution would be an automatic , 904 , 998 or a GM TH 2004R with a new mount.