Well, that's a "Yes" and "No" answer. No to get them to fit with the aftermarket brackets and bolt in but I didn't like the height of the seat position and my head felt close to the headliner...you see this a lot with aftermarket seats and in my opinion just doesn't look right. I cut off the mounting tabs and made lower or flat tabs to lower the seat closer to the floor, that's where I ran into a problem. The floor has a built in riser that interfered with the seat so I cut that riser out and made a flat floor so that now when I sit in the seat my shoulder is just below the top of the door. The first picture is the untouched bracket, the second is the difference in the mounting tabs, the third is the seat riser that was in the way and the last is the modified floor with the seat in place.