67 Dart 270...Project Old School
Last night I measured for the new driveshaft. I will take my existing one and have it cut down and swap out the 904 spline yoke for a 727 spline yoke. The measurements the shop wanted were from the yoke on the rear end to the end of the transmission case where the seal mounts. Then they wanted a measurement to the end of the seal and also a measurement to the end of the output shaft.
From the yoke on the rearend:
49 1/8" to the end of the transmission case where the seal mounts.
48" to the end of the seal.
47 7/8" to the end of the output shaft on the transmission.
I will drop off the driveshaft to be shortened today at lunch and hopefully have it back before the weekend.
Last night I measured for the new driveshaft. I will take my existing one and have it cut down and swap out the 904 spline yoke for a 727 spline yoke. The measurements the shop wanted were from the yoke on the rear end to the end of the transmission case where the seal mounts. Then they wanted a measurement to the end of the seal and also a measurement to the end of the output shaft.
From the yoke on the rearend:
49 1/8" to the end of the transmission case where the seal mounts.
48" to the end of the seal.
47 7/8" to the end of the output shaft on the transmission.
I will drop off the driveshaft to be shortened today at lunch and hopefully have it back before the weekend.