Those tools are priceless when you charge for a bushing replacement and it only takes 10 min to do it. :D
I bet. I learned a long time ago good tools can quickly pay for themselves
If I remember there is a channel cut on the bottom right (about the 5 o clock position) that the oil hole on the bushing lines up with.
I can't seem to find a picture of one, but I'm pretty sure about it, and a little known fact about why at the 5 o clock position and not straight at the bottom where you would think the most fluid would be was because the spinning internals blows the fluid over to that side and then it runs down the channel to the bushing.
Trip huh? :-)