Engine Temp
Hey Lads,
I'm using the hotwireauto harness. I have an ENGINE TEMP SENSOR located just behind the water pump near the intake manifold. On the other side of the engine I have a wire with ENGINE TEMP GAUGE, this also runs to inside the cabin.
DO you have to run a separate TEMP sender for those wires? If so where do you install it? Is it possible to tap/splice in to the ENGINE TEMP Sensor wiring?
I assume that the ENGINE TEMP Sensor wiring transfers data to the ECU only as it has no continuity to the ENGINE TEMP GAUGE wiring.
Hey Lads,
I'm using the hotwireauto harness. I have an ENGINE TEMP SENSOR located just behind the water pump near the intake manifold. On the other side of the engine I have a wire with ENGINE TEMP GAUGE, this also runs to inside the cabin.
DO you have to run a separate TEMP sender for those wires? If so where do you install it? Is it possible to tap/splice in to the ENGINE TEMP Sensor wiring?
I assume that the ENGINE TEMP Sensor wiring transfers data to the ECU only as it has no continuity to the ENGINE TEMP GAUGE wiring.
