No spark Mopar dizzy and FBO box & coil

Update, I unplugged the dizzy pick up harness, turned key to run, pulled coil wire off the dizzy cap, everytime I touched the male end of the dizzy harness to ground I got a spark off the coil wire that jumps 1/4 inch. This is supposed to point toward the pick up coil. So I do another test for the pick up coil to make sure, set meter on ohms, ground one end of meter and touch either side of the pick up coil wires coming off the dizzy, if any reading the pick up is bad. My test showed no reading WTF! One test shows one thing another the opposite! So I pulled the 2 wires that run to the pickup coil from the ECU out to inspect them and checked voltage at he coil - and + again, I now had 8volts + side and 1.6volts on - side, I had 11.6 on both sides yesterday? So I thought I will check for spark at the plug wires, I HAVE SPARK! So I try and fire it up, touch the key and it takes off! I am still not sure what happened, I am thinking the pick up wires in the harness from ECU has a bad spot and it. I checked continuity on them while wiggling them around but they were fine? Going to check them out closer tomorrow and check the coil - wire also as it was run with the other 2 wires in question.