Father-Son 1974 Duster Project
Our motor is about complete, 904 is getting the shift kit installed, have the right flex plate and stock high stall torque converter. Motor mounts are on hand, and I have the stock 2 bbl kickdown linkage and I'm not sure, but I don't think it will work with my Holley..
I hate to make lists! However, here is a list of things I need to get to get Misty moving and stopping on her own
- filler tube gasket
- tank to pump fuel line
- Mopar electronic distributor with hold down
- HEI module
- coil
- spark plugs
- spark plug wires
- all hoses
- stock radiator
- fan
- shroud
- starter relay
- battery
- battery cables
- fuel pump to carb line
- stock air cleaner element
- thermostat
- power brake booster with master cylinder
- brake line to wheel cylinder hoses
- front and back brake wheel cylinders
- rear brake shoes
- front brake pads
Now I need to throw up:wack:
OK that's a little better. We also need:
- transmission cooling lines
- floor shifter
- manifold back 2.5" dual exhaust
Also need to figure out what we need to do the Alternator gauge bypass upgrade.
I love this project, it is very rewarding to make progress. But I have to admit, It was less stressful when we were tearing her apart, cutting, hammering, grinding and welding away....
I hate lists:banghead: