66 dart convertible

And I'm going to try and keep the power steering, A/c AND add an engine mounted turbo on my /6. I am looking for early a-body pictures of the fender well header cutout areas so I can better think through the placement of my turbo (rear mount would work but the darn scavenge pump makes it a bit of a mess and added expense for me to mock up). sooooo I was thinking (ya, I know bad idea right?)I might get enough room for the front turbo if I move it over to the area on the passengers side where a fender well header cutout would be on the passengers side and clock it to fit. so any pictures of the passengers side inner fender that's been cut for the headers would be appreciated to help me mock it up on a parts car first. and for the underside crossover I could go either way since it does not matter much to the turbo (<10psi boost)what shape the pipe is as long as it gets the exhaust flow. so 2.5" pipe with a slightly flattened 3"area welded in at the area under the oil pan or between the trans pan and bell housing to the passengers inner fender should work.

View attachment !!!!!here or here.jpg



of course I'll have to figure out how to add an inter-cooler into the radiator,a/c condenser area without chopping up too much stuff, but that's what a spare front section of a parts car is for:D