Steve's 70 Gen III Hemi Build

Once it was positioned in place I just used a couple pieces of threaded rod to help with line up as it was going down.

I decided to go with the A518 transmission so once I cut the old torsion bar mount out of the way I only have to massage the floor board a little in a couple placed and make 1 small cut to open up an area for the overdrive unit. Other than that it fit right up in the floorboard and looked good. Its tight but it fits :cheers:

My crossmember is kind of crude at the moment, I plan on welding the large plate to the frame to help connected the front. I will either weld some nuts on the back of that plate to bolt the crossmember in or put some nutserts in the plate not sure yet. Once its all welded together and smoothed out it will get powdercoated.

The transmission is an empty case just incase some of you are wondering :)