1972 Canadian H-Code 340 Dart Swinger Special Resto - Finally started!
I haven't managed to work on the car much the last two weeks but got a bit of sandblasting done the other evening on the areas that have some surface rust and the weld areas.
Cleaned up and needs some epoxy then I can set the tub back in place and trunk floor drop and hopefully get those two welded in this weekend. I want to clean the inside of the rocker out while its open on the end and spray some Eastwood encapsulated sealer inside as well.
View attachment 1715161788
I also decided to remove the factory wire harness straps from my old trunk drop and put them on the AMD one since theirs were quite a bit shorter then the originals and the only had two instead the three that the factory had.
Epoxied the drop and tub while they were off so their ready for putting back in place and a final test fit then weld them in place.
Hopefully I can get a bit a accomplished this weekend.
View attachment 1715161778
View attachment 1715161781
I haven't managed to work on the car much the last two weeks but got a bit of sandblasting done the other evening on the areas that have some surface rust and the weld areas.
Cleaned up and needs some epoxy then I can set the tub back in place and trunk floor drop and hopefully get those two welded in this weekend. I want to clean the inside of the rocker out while its open on the end and spray some Eastwood encapsulated sealer inside as well.
View attachment 1715161788
I also decided to remove the factory wire harness straps from my old trunk drop and put them on the AMD one since theirs were quite a bit shorter then the originals and the only had two instead the three that the factory had.
Epoxied the drop and tub while they were off so their ready for putting back in place and a final test fit then weld them in place.
Hopefully I can get a bit a accomplished this weekend.
View attachment 1715161778
View attachment 1715161781