Enderle mechanical fuel injection, on the street?
Thanks forbthe heads up about mega squirt, I had forgot about them.
What makes u say there a better product?
.
Megasquirt is a DIY system. In fact it started out soldering the boards together. You can now buy them either way, assembled or not.
The good about MS is that it's VERY configurable and versatile, the bad is you have to "do it yourself." They are however reasonably priced
I've read some on using EFI with ITB system, and there's a lot of "ifs." You don't HAVE an intake manifold with "8 stack" , so there's nothing there for a vacuum signal. I saw at least one project where the builder essentially built an intake plenum, IE interconnecting all the throttle bodies into a "can" to provide a vacuum "pot."
Some say the way to do it is to NOT to us a map sensor, (speed density) or maybe, NO map sensor, and instead tune it instead with Alpha N
You can't use MAF (mass air flow) as there's no way to get "mass" air flow
This leaves "Alpha N" which can be used but is not as sophisticated. Somewhere I read that the Holley HP series computers can be cnfigured to run Alpha N part of the time and speed density part of the time
If you review the (damn little) tech info that came out of the "Blasphemi" project, I think there was a mention in there about getting enough vacuum signal for the MAP