70 Duster Eagle Hemi Swap, No Spark!

I currently don't have my ecu I sent it to get it checked and remove the skim. There were two wires I connected to battery +.

one was C1 pin #11 Fused ignition switch circuit (Run-start)
The other was C1 pin #12 Fused ignition switch circuit (off-Run-start)

Then by touching the wire from C1 Pin#30 ignition switch output (start) to the battery + I could get it to crank just no spark.

I was trying to get it to fire on starting fluid on the floor to test my wire harness and didn't have a fuel pump hooked up to it. I didn't think that this would be an issue due to the fact that there is no fuel pressure sensor to tell the ecu if there is fuel.