Anyone running a hydraulic clutch with their 833?
I used a mismatch of Jeep master and slave from two different models from the mid 80s I believe. I had a post about it several years ago on here but may be long gone by now....
This slave is very much like the one I used from 80-86Jeep CJ models. It had enough travel that I use the stock push point in the fork.
This is like the master Cylinder I used from a 86 Cherokee series.
You can see the master cylinder mounted here. I did fab a reinforcement plate for the mounting and removed the spring from the pedal as well as welded up a place where I drilled and tapped a hole for the shaft that went through the apply rod on the pedal arm.
[/IMG]
Took me a while to figure it out again but the edits should be correct now.
I used a mismatch of Jeep master and slave from two different models from the mid 80s I believe. I had a post about it several years ago on here but may be long gone by now....
This slave is very much like the one I used from 80-86Jeep CJ models. It had enough travel that I use the stock push point in the fork.
This is like the master Cylinder I used from a 86 Cherokee series.
You can see the master cylinder mounted here. I did fab a reinforcement plate for the mounting and removed the spring from the pedal as well as welded up a place where I drilled and tapped a hole for the shaft that went through the apply rod on the pedal arm.
Took me a while to figure it out again but the edits should be correct now.