Using lead to fill trim holes

Went much better today. Taught myself a few tricks, like if the blob of lead falls off the hole, just lube the paddle up and scoop up the lead. Hold it under the hole on the paddle and heat it there, spreading it once it’s hot. Also backed the holes with 600 degree Ducting tape from 3M on the back of duct tape and put it on the back side to clean the inside up too. I think starting with the body panels was a mistake for a novice as the holes are bigger and vertical, so I would recommend getting the hang of it first before tackling these. Thanks to everyone for your advise with this. I’ll post some pictures when I’m through.