1972 Canadian H-Code 340 Dart Swinger Special Resto - Finally started!
Hung the quarter on hopefully the last time to layout where the plug welds will go and drill for those and mark where I want the spot welds to land. A lot of prep needed since I'm going to use some Fusor panel bonding at the rear cowl and corner of the window as well as the weld thru seam sealer on the areas I can use the induction spot welder. Once you lay the panel on this stuff you don't want to have to move it or you'll have a bit of a mess to wipe off.
I happy how the inside turned out and should look like factory except a little shinier.
Picked up my parts from the dipper today turned out overall not bad but I think Hemiorangeswinger's turned out a bit better then mine, Randy what's up LOL!
Unfortunately they dropped my hood on a bad spot at the back, now any spot is a bad spot on a hood, looks like it slipped out of someones hands lifting it and it landed on the edge of the tank. I put the hammer and dolly to it and it came out pretty nicely in about 15 mins so it turned out to be not a big deal.
Spent some time sanding the hood down, lost some hood brace adhesive globs and some have come loose so I need to replace those before I do anymore on the hood.
Hung the quarter on hopefully the last time to layout where the plug welds will go and drill for those and mark where I want the spot welds to land. A lot of prep needed since I'm going to use some Fusor panel bonding at the rear cowl and corner of the window as well as the weld thru seam sealer on the areas I can use the induction spot welder. Once you lay the panel on this stuff you don't want to have to move it or you'll have a bit of a mess to wipe off.
I happy how the inside turned out and should look like factory except a little shinier.
Picked up my parts from the dipper today turned out overall not bad but I think Hemiorangeswinger's turned out a bit better then mine, Randy what's up LOL!
Unfortunately they dropped my hood on a bad spot at the back, now any spot is a bad spot on a hood, looks like it slipped out of someones hands lifting it and it landed on the edge of the tank. I put the hammer and dolly to it and it came out pretty nicely in about 15 mins so it turned out to be not a big deal.
Spent some time sanding the hood down, lost some hood brace adhesive globs and some have come loose so I need to replace those before I do anymore on the hood.