T-56 Transmission Install Thread

For anyone that has made the throwout bearing spacer or has a throwout bearing loose they could measure, any chance I could get some dimensions? I'd really like to get one cut out and have it ready before I pull the trans. That way I can pull the trans, install the spacer, and put it right back in as opposed to having to pull everything out, measure it, get a spacer made, and put it back in with a few days thrown in the middle for good measure. I'll be doing this in a driveway, so the closest I can get it to a one day/weekend job the better. 72BBSwinger posted a good picture of his spacer. If I could get a diameter for the whole thing as well as the bolt holes and center hole and the spacing between the mounting holes I'd really appreciate it. Have a source with material that can make it, just need a drawing.

Edit: Okay, I feel a little silly now. I swear the last time I read the post the dimensions weren't listed, but I just re-read it and found most of the info I need. The main thing I'm missing is the throwout bearing mounting bolt hole size and locations. The diameter for the blank and input shaft hole were on the post I was just reading.