FiTech EFI system

Hi, To answer your question, I will be running the fuel vent line under the car back to the trunk.. I am teeing into the fuel vent line (on the low side right beside the filler tube. I talked to Fitech about it and they felt it should work.

On another note... I got it started tonight, but have to let you know about a little problem i had ( now resolved) When I activated the system it poured about 2 inches of fuel in each of the four throttle bores... Not Good, obviously.. I turned off the power and soaked up the fuel with some rags.

Got on the phone with Ken, at Fitech ( i think the owner) and he quickly asked if I was using a msd digital 6. IMPORTANT NOTE ( he will be adding to his instructions) If your MSD displays the rev limit when you turn the key on, the EFI thinks you are at redline rpm, thus the gobs of fuel. Turned that off, cleared the fuel out of the motor, without starting, and the motor fired right up. I had to unhook the EFI tach feed line to turnoff the redline display option FYI

It has NEVER idled at 14.2 at idle before.. Quite impressed.

VENT LINE i didn't have it on as I warmed the engine... and after about 10 minutes, there was some fuel spitting out of that line.

No more running until I run the vent hose line, which I should be able to get done Sunday.

BTW the handheld controller is extremely easy to use, and I was able to richen the idle mixture and change the idle speed quite easily from inside the car.

Gonna like this a lot. Will post some more pictures and info as I get it on the road next week!!