1967 Cuda FB project

Hmmm... - Good point. A slimmer, less squared bumper protrusion would simulate the factory closer. I think it still works but you'd need to duplicate this look on the rear then.

That is what I am trying to get to, a slimmer bumper. Just didn't want to take too much off before I got the dr side matched up. If you look close, you can see I am shaping that way on the right upper corner. The whole top is shaped that way, you just can't see it well in the pics. I want to take more off the bottom side to match. :D
View attachment WP_20150913_022.jpg