1966 Dodge Dart

View attachment DSCN4216.jpg

View attachment DSCN4218.jpg

View attachment DSCN4219.jpg

View attachment DSCN4220.jpg

View attachment DSCN4233.jpg

View attachment DSCN4234.jpg

Finally got my old computer back so I can post some pics to go with the updates. Here are pics of the brake piping so far. I spent a lot of time bending this piping hoping that it turned out ok. Sometimes I think its a waste of time but it should last forever since it will be kept inside and not driven in the rain unless I get caught in it. As you can see I mounted the proportioning valve on the inside of the frame just below the drivers floor. It makes it very difficult to install the upper lines but they will fit. Also I put the heat wrap on much of the lines because of the closeness to the head/exhaust pipes. I dont know if that will deflect heat from the lines but it cant hurt. I still need to run the one line from the cylinder to the valve and a line from the valve to the rear of the car.
Rod