exhaust manifolds

Haven't been working on the car much. There is at least an inch of room around the column. Put the kickdown linkage on plenty of clearance. I used flange with two inch id pipe purchased at local parts store then a 45 degree angle pipe weld to that on the passenger side. Then a flange with a slight bend that cleared the starter. Found it laying on it ground in the junkyard no idea what it is off of but it had the two inch opening, I then welded a 90 degree pipe to it on drivers side Both sides dump out at the same place headers would have. My cross member was already modified for TTI headers and their 3 inch exhaust so running the rest should not be a problem. I was thinking of using a kit from Jeg's or Summit from a 67 up abody for the rest.