72 360 first start question

Ok so i followed your procedure to the tee. and it looks good. I measured my valves at exactly that moment when the exhaust valve is closing and the intake valve begins to open on the non compression stroke and at 2-3 deg. BTDC they are exactly the same 1.770 inches. It's difficult to get a caliper on the springs so i used a feeler gauge held tight up against the spring touching the seat and made a mark on it with a sharp awl. I was careful to make sure that i put the feeler gauge in exactly the same position on the other valve. then I measured the marks with the caliper. So does this suggest that my cam is not out of phase? Here's hoping.