Gang Green 68 GTS

Quick update. I finally got the torsion bar boots and clips so I could tighten up the front end. I bought poly strut rod bushings also, but didn't like the way that they kept the lower control arm shafts from seating all the way. I think they were to stiff and too thick. I replaced them with regular Moog's. Getting the Poly frame bushings on the front sway bar was another issue. Had to drill relief holes in the old bushings and pry them out. That's when the trouble started. Could not find a way to get the new stiff poly bushings into the welded brackets after I was able to get them over the large ends of the bar. Finally I gave up trying different methods and cut the factory welds. Then assembled them and pressed the brackets back to closed and re welded them. Not sure how everyone else does them, but I gave up trying to fab tools and pressing into place.

View attachment WIN_20151024_134316.jpg

View attachment WIN_20151024_134324.jpg

View attachment WIN_20151024_134343.jpg