Thanks to all for the input, it looks like I am going to learn to CC head chambers. Also, I need to buy a degree wheel if anyone has any recommendations.
Thanks---Douglas
You can get this ^^ separately and then come up with a piece of plexiglass, cut it to size and drill a hole.
I just found it easier to buy the kit. You will need a funnel with a very small spout to fit the hole. I also picked up a syringe and put a small piece of heat shrink tube on the end to suck some of the liquid up through the hole so I could put it back in the bottle before pulling the plexiglass off, that way you don't keep losing it all over. I use rubbing alcohol with green food coloring in it, it helps to be able to see it better to be sure all of the bubbles are out.
You will probably want a dial indicator as well, ifn you don't have one.
When cc'ing the heads I just use grease around the hole and work the plexiglass onto it, it was sufficient to hold it in place. Be sure to use enough so you get a good seal.