Slant 6 Turbo 68Dart Project

Hi,

I had a lot of fun reading this thread overtime and I don't want to hijack this thread but I need some help with my setup. This is my thread on the slant six forum: http://slantsix.org/forum/viewtopic.php?t=55812&start=30

Long story short - I had an engine built about 4 years ago with: Weisco pistons, 268 cam kit, stock rods, efi with powerjection, and megajolt ignition.
Had bad misfires and recently checked compression as last ditch effort on each cylinder. Read low (90psi) and the same on each cylinder. Found out you can't use stock 225 rods with the weisco pistons... :oops:
I know it isn't the builders fault but I wish he would have caught that it's about a 1/4" in the hole.

My question is what should I do now because I eventually wanted to turbo charge the motor?

Loving the work you have been doing OP
Keep it up!