8 point roll bar

Ok so for this first post is what I've done today so far and where I'm a little stuck as far as exactly where to put the six by six plates? But I'll get to that after I show what I've done so far and part of what I've done is lining up my uncles Eragon wire feed welder for next weekend. I took my cutter grinder and cut out the window in the back frame rail which is a perfect fit for the one and a half by two and a half rectangle stock. I took the 4 footers and used the tape to measure out 3'9" and cut a notch out of the last three inches for the front. I wanted to slip the back in far enough to weld through the hole in the bottom to ad more stability in the back by the jack stand.
View attachment 20151206_103735.jpg

View attachment 20151206_114104.jpg

View attachment 20151206_113919.jpg

View attachment 20151206_112859.jpg

View attachment 20151206_113938.jpg