66 Dart GT HT Whatsitgonnabe?

Went to Biltema to pick up some stuff. I replaced the driver's side constant velocity joint boot on my old Audi a while back and the other week I noticed rattling. The clam that holds the boot in place in the wide end had come off (I didn't use a proper tool to clamp it) and all the grease - really expensive MoS2 stuff) was on the inside of the rim - again.

I temporarily fixed it by addind what little I had left of the grease and wrapping a couple of turns of mild steel wire around it real tight around it. Today I got a proper clamp and the tool for it for cheap at Biltema.

And I got a vacuum gauge. I figured I needed one. I also got a 6 kg (13 lbs) powder fire extinguisher for the garage. A little safety can be a good idea.

Then I replaced the destroyed exhaust ducting I made last week. Got a new flexible duct, one with a steel wire in it. It's holding up but flapping around way too much at low rpm. I think the ventilation grate with mose and mosquito net is too much of an obstruction so I think I'll need to remove it. Too dark and cold right now, though.

Oh, and I plugged the speedo gear hole with an old Kelsey-Hayes piston and a few turns of electrical tape. :thumblef:
.