Header Headache
Almost as easy as using a fork.
Jees those things are dangerous, and you don't poke holes in your face with your fingers.:D
There is a sequence that if followed makes headers not bad at all.
My own had that sequence.
Unbolt the motor mounts
Raise the car about 30 inches in the air
Pull the steering center link
Pull the starter
Raise the engine
Push it over to the passenger side
Start the header in straight up on end right in front of the bell
Tilt up into place
Put it all back together running the center link through the header tubes. (no big deal) :D
I run 1.03 T bars and 15" 70 tires and blast right through parking lot transitions and such without any problems.
Oh, and a hundred bucks says I can pull either torsion bar in 15 min or less with nothing but a pair of needle nose pliers and a floor jack.