Gen 3 Hemi dual plane.

I haven't made any commitments on engine yet for my project. I want to preserve some old school look, so would be interested in a Carb version. Do you think the fuel injector lumps could be "shaved" off and then "textured" with something like a needle scaler then camouflaged enough with paint? The area looks meaty enough.
Don't ridicule me for a dumb question-I know the serpentine front end & the plug wires are gonna give it away but.....
Speaking of plug wires, could the coil packs be reversed so the wires come out the back?
You know what would clean stuff up a bit too is if someone made plug wires that shared a common jacket and split just above the valve covers, or were molded with a dually plug.
I like your dyno sheets, you got a decent bump earlier on, from 3750 to 4300, then where you are down its not by much and you got more going out on the top end. Hard to tell but your roll off on the top may not be as steep either. Be cool to see this on something modded.