Magnum swap starts, does not run

I wanted to update this thread. I spent the last couple months cleaning up all the wiring and getting it put into place. I did not find anything wrong while going through it. I had my EE friend figure out my crank sensor wiring to be sure on that.

Car still would not start!

I swapped in the manual transmission PCM and boom! It started. It stumbled around a little bit learning some stuff, but then settled into a nice idle. I was able to pull it back into the garage under its own power. (I would have tried going around the block, but I have to align the front end first)

I'm not sure what is different between the two PCMs but that seemed to be the issue in my case.

Thanks again for all the help provided here.