Tranny removal. Stuck!

Sounds like you didn't loosen the converter bolts. Also, there is no 'flywheel' in an automatic, just a 'flexplate'. The flexplate attaches the converter on the outer ears and is bolted to the crank flange on the inside.

Put two bolts back in the bell and bolt it back up to the motor. Once it's back into place then undo the the converter bolts. ALWAYS do the converter bolts first or you end up in the situation you are in.

You have to spin the motor over with a breaker bar to rotate the bolts around. Take a look when you get the bolts out, there is usually one oblong hole, just make sure you remember where it is when you put the trans back in.

When you are trying to loosen the converter bolts, make sure the motor can not rotate backwards, put a prybar in the converter teeth to keep it from rotating. Converter bolts can be a pain to loosen, they round off easily.

Also, support the back of the engine with a block of wood under the pan.

Holla back if you need more help.