Opinions on low end 360?

sireland67 said

Thanks, the gas motor will act almost like a diesel, but rev a little higher, but I never spin the old girl over 3500 rpm.
I only use it to pull with or haul lumber.

So to the op build the motor as you intend to use it, you will be much more satisfied.
A smaller cam is more forgiving than one that is too large.

Click to expand...

Sounds very much what I'm looking for!
What parts did you use? Carb, intake, cam, exhaust manifolds? Compression ratio?

I wrote Performer RPM in my first post but was thinking Performer. There's a RPM on my engine now. Sorry for the mix up.
Could the old SP2P be an option, or is LD4B better? Very difficult to find information about low end torque since everybody is looking for maximum power.