360 Oil Dip Stick Tube Angle/Placement Into Block

I know this forum has tons of information, but I may not be searching for the correct key words or something. Since I did not exactly find a thread that specifically went over the angle of the dipstick tube should be at. However I did find quite a few on broken oil dipsticks and tubes though.

So the other day I went to check my oil level, and the dipstick was really tough to remove then even harder to put back in. Felt like it was hitting something and getting stuck somewhere but I was able to get the dipstick back in.

Then yesterday I was checking the level again and while trying to place the dipstick back into the tube the tube rotated.

I then attempted to rotate the dipstick tube in different positions to see what would allow the oil dipstick to more easily be placed back in. Below I have attached a pic of the placement it was angled at before and where I left it last night (I have not attempted to start the car).

I am not too familiar with where the dipstick will interfere with anything in regards to placement. So figured to ask more experienced fellows if the actual angle will hinder anything.

I did find this thread that had some good pics, but the dipsticks seem more upright and pointed back to the block than mine.

http://www.forabodiesonly.com/mopar/showthread.php?t=44532&highlight=dipstick+angle