AlV 69 Dodge GTS project

Arrived home to find a huge box from TTI next to my door :)

It's the 2.5" H-pipe (#A25MWM6776) system but it had 2 caveats.

• A-body applications w/ mfd casting #'s 2863553, 3614368 / Auto Trans w/ a 3-section kick-down link: Modification may be required to the lower throttle rod.
  
• A-body applications w/ mfd casting # 2863549 / Standard Trans: A 90° oil filter adapter will be required

The 90° degree adapter was a non issue since I had it installed already, But the linkage mods that was a completely different story. You know just as much as I do how expensive these original 340 kick-down setups are and modding them was not something I was interested in. (See mods in image below)

I intend to install the 3 piece linkage so I called the folks at TTI and we came up with the idea of using the drivers head pipe from the 4spd setup. The 4spd head pipe is designed to clear the clutch pedal z-bar which gave us the clearance we needed for the linkage. It does this by dropping a little lower and stepping from 2.24" from the manifold to the bend) to 2.5".

Because I'm using the stock manifolds I am okay with the trade-off.